Black and Decker GSL35 Manual De Instrucciones página 4

Features
1. On/off switch
2. Lock-off button
3. Blade release button
4. Grass Shear blade (GSL35,
GSL75, GSN30, GSN35)
5. Shrub Trim blade (GSL35,
GSL75, GSN32, GSN35)
6. Blade cover (not shown)
Assembly
WARN IN G:Avoid
accidentally switching
the t ool
on
during assembly,
Fitting and removing the
blade (fig. A, B, C)
The shear blade (4) has been
designed for trimming grass and
weeds. The trim blade (5) has been
designed for trimming hedges and
shrubs.
• To remove the blade cover (6).
Push and hold the blade release
button (3) in the direction of the
arrow (fig. A)
• Slide the blade cover (6)
backwards and lift it off (fig. A-l).
• While holding the blade onto the
pins (Fig. B), locate the blade cover
(6) and slide it forward (fig. C).
O
Note: No alignment of blade with drive
pin isrequired and operation of the blade !,_ -2_
cover release button is not requiredwhen (_6
re-fittingthe blade cover. ........
Charging Procedure
The baffery needs to be charged before
first use and whenever itfails to produce
suffident power on jobs thatwere easily
done before. When charging the battery
forthe first time, or after prolonged
storage, it will only accept an 80%
charge. After several charge and discharge cycles, the battery will attain full
capacity.The battery maybecome warm while charging; this is normal and
does not indicate a problem.
/t, WARNING:
Do not charge the battery at ambient
temperatures below 36 ° F (2°C) or above 104°F (40°C).
Recommended charging temperature: Approximately 75°F (24°C).
• Note: The charger plug incorporates lock outs to prevent the use of incorrect
chargers.The plug must be correctlyoriented when inserted.
• Insert the charger plug into the charger connector at the rear of the
tool (fig. D).
• Plug the charger into a 120V outlet. __ ........................... f--
Charge the tool for 16 hours before first use.
For catalog numbers GSL35, GSL75:
The charger indicator light will come on
indicating that the tool is charging. -............ "-,
When the charge is complete the lightwill go out.
For catalog numbers GSN30, GSN32, GSN35: _i_
The charger indicatorlightwill come on indicating _
that the tool is charging.
The light will stay on as long as the charger is connected to the
tool and pluggedinto a working outlet.
ItWILL NOT flash, or go out when the charging cycle is complete. To
maximize the lifetimeof the battery,it is recommended to keepthe battery
connected to the charger whenever the tool is not inuse. When the battery is
full, the power consumption of the charger is negligible.