Frequently Asked Questions - babymoov Hygro+ Instrucciones De Uso

• Follow these cleaning procedures to guarantee proper and
efficient operation. Good maintenance is essential for the
humidifier's long life and to prevent the proliferation of bacteria
in the water, inside the water tank, or in suspension.
• Always unplug the humidifier before cleaning and wait until the
base has cooled.
• Wipe the humidifier with a soft damp cloth or sponge. Allow it
to air dry. Never immerse the base in water or any other liquid.
• Clean the water tank regularly with a mix of chlorine bleach
and water.
• Rinse with water and allow it to air dry.
• Never use detergents to clean any parts of the humidifier
intended to contain water. A cloud of detergent dissolved in
the water could interfere with vapour production.
Should I add hot or boiling water to the tank to improve
vapour production?
No, doing so could permanently damage your humidifier.
Hygro+ produces cold vapour using ultrasounds, so it does not
need hot water. Add cold water or water at room temperature.
10
CARE AND PRECAUTIONS FOR USE
• Remove the base regularly. Pour 250 ml of pure white vinegar
• Gently scrub all parts around the transducer using a soft brush.
• Never use cleaning agents, solvents or abrasive substances as
• Before storing, empty the water tank and any water in the base,

FREQUENTLY ASKED QUESTIONS

Some water is left in the tank. Should I empty it?
Yes. You should change the water regularly to prevent the
formation of mould or the proliferation of bacteria inside the tank.
When you do not plan to use the humidifier for an extended time,
empty any water and let the humidifier air dry before storing.
into the base. Let it sit for 20 minutes while you clean all the
internal surfaces using a soft brush.
Do not press directly on the transducer. Empty the vinegar
solution into the sink. Rinse with clean hot water.
they could damage the humidifier and its surfaces.
respecting the icon indicating how to pour the water. Ensure all
parts are completely dry, then loosen the plug to prevent the
joint from sticking.