Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tempermure
Controls
Adjusting
the Controls
• 24 hours after adding food, you may decide that one
or both compartments
should be colder or warmer. If
so, adjust the control(s)
as indicated
in the
Temperature Control Guide table at right.
See
page 20 for instructions
on checking
compartment
temperature.
• Except when starting the refrigerator,
do not change
either control more than one number at a time.
• Allow 24 hours for temperatures
to stabilize.
• Changing
either control will have some effect on the
temperature
of the other compartment.
Temperature
Control Guide
Refrigerator
too warm
Refrigerator
too cold
Freezer too warm
Freezer too cold
Turn refrigerator
OFF
Set the Refrigerator
control
to next higher number by
pressing the
pad.
Set the Refrigerator
control
to next lower number by
pressing the
pad.
Set the Freezer control to
next higher number
by
p re ss in g th e
pad.
Set the Freezer control to
next lower number by
pressing the
pad.
Press the Freezer or
Refrigerator
_
pad until
a dash "-" appears in the
display.
Fresh F ood Features
Shelves
Your refrigerator
has either Spillsaver
TM
or non-sealed
shelves. Spillsaver
TM
shelves have a spill retainer edge
which allows for easier clean up and some are
equipped with the EasyGlide
TM
slide out feature. To
slide out (select models), grasp the front of the shelf
and pull forward.
Push in the shelf to return to the
original position.
To Remove a Shelf:
• Slightly tilt up the
front and lift up the
rear of the shelf, then
pull the shelf straight
out.
To Lock the Shelf Into Another
Position:
• Tilt up the front edge of the shelf.
• Insert the hooks into the desired frame openings
and
let the shelf settle into place.
• Be sure the shelf is securely locked at the rear.
The Crisper Top serves as the lower fresh food shelf.
To Remove the Crisper Top:
• Remove drawers as indicated
(see page 11).
• Place hand under the frame to push up the glass. Lift
glass out.
• To install, repeat above instructions
in reverse order.
SideGlide
TM
Shelves
[select models)
SideGlide
TM
Shelves can be
adjusted to create a full-
width shelf, or to slide from
side to side to accommodate
storage needs.
To Remove Shelf Rail
Assembly:
• Lift rail assembly up to remove hooks from frame.
Publicidad
Capítulos
Tabla de contenido
