DeWalt D25133 Manual De Instrucciones página 31

FIG. 1
J
F
I
G
H
Side Handle (Fig. 2)
WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed and securely tightened. Failure to
do so may result in the side handle slipping during
tool operation and subsequent loss of control. Hold
tool with both hands to maximize control.
A side handle comes assembled with this rotary
hammer. The side handle (H) can be fitted to suit
both right-hand and left-hand users.
D25133, D25134
C
O
A
D
E
B
FIG. 2
H
29
J
F
I
G
H
TO ADJUST THE SIDE HANDLE
1. Loosen the side handle (H) by turning it counterclockwise.
2. Rotate the side handle to the desired position.
3. Tighten the side handle by turning it clockwise.
Trigger Switch (Fig. 1)
To start the rotary hammer, depress the variable speed trigger switch
(A). To stop rotary hammer, release the switch.
NOTE: Use lower speeds for starting holes without a centerpunch,
drilling in metal, plastics or ceramics, or driving screws. Higher speeds
are better for drilling in masonry for maximum efficiency.
A
B
C
D
E
D25260