Accessories; Repairs; Environmental Protection; Technical Specifications - Metabo KHE 55 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

17026727_0107 NAFTA KHE 75 KHE 55.book Seite 9 Freitag, 26. Januar 2007 8:40 08
Slow flashing - carbon brushes worn (only KHE 75)
The carbon brushes are almost completely worn. If
the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorised service centre.
Continuous light - Service call-up
The tool cut out automatically. Bring the tool to a
Metabo Service Centre.
Rotational speed fluctuations:
High-energy, high-frequency interference can
cause rotational speed fluctuations up to the
maximum idling speed. The fluctuations disappear
again as soon as the interference fades away.

11 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4:
A Extensive range of chisels for a wide variety of
applications.
B Special grease (for lubricating the tool shanks)
C CODE! key

12 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

13 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.

14 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
U
=
Voltage
I
=
Current
P
=
Nominal power input
1
P
=
Power output
2
n
=
No load speed
1
D
=
Drill diameter in concrete with
1
hammer drill bits
D
=
Drill diameter in concrete with core
2
cutters
s
=
Impact frequency
W
=
Single impact force
C
=
Number of chisel positions
m
=
Weight without mains cable
Wear ear muffs!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH
ENG
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Khe 75

Tabla de contenido