Installing The Electrical Kit - Westfalia Automotive 306 231 300 107 Instrucciones De Montaje

Installing the electrical kit

1. Disconnect the negative battery terminal.
2. Remove the spare wheel.
3. If necessary, remove the following coverings and panels:
·
In the luggage trunk
Luggage trunk floor cover
-
Covering of the rear end plate
-
Covering of the right and left trunk side
-
4. Bore a hole of 40 mm for the cable leadthrough (Fig. 1/6) on the left-hand side of the spare
wheel well.
5. Starting in the luggage trunk, lead the socket end of the cable harness through the cable
leadthrough to the outside and from there to the socket holder plate (Fig. 1/7).
6. Insert the rubber grommet into the cable leadthrough (Fig. 1/6).
Socket installation
7. Press the contact insert into the socket housing and push the rubber grommet towards the
socket.
8. Screw the socket onto the socket holder plate (Fig. 1/7) using the supplied screws and nuts.
Connecting the tail lights
Note
When connecting the tail lights, select the suitable adaptor according to the Cable harness
overview chapter!
9. Lay the cable end with the left-side marking to the left-hand tail light.
10. Disconnect the plug-in connector of the left tail light (Fig. 1/2) and connect it to the matching
counterparts on the cable harness. Make sure that the plugs lock firmly into place.
11. Lay the cable end with the right-side marking along the rear end plate to the right-hand tail
light.
12. Disconnect the plug-in connector of the right-hand tail light (Fig. 1/8) and connect it to the
matching counterparts on the cable harness. Make sure that the plugs lock firmly into place.
22 306 231 391 101 01/03
Installation instructions:
Electrical system for towing hitch
Fiat Stilo