Washer Use - Sears Kenmore He2 Plus 110.4751 Serie Manual De Uso Y Cuidado

WASHER USE
STATUS MODIFIERS & OPTIONS
Power
Delicate
Add a Garment O
Prewash / Wash 9
n
Rinse _ Heavy Dtlt_/ Auto TempControl
Spin _ Hot / Cold
1.2
Prewash
Clothes Clean O Whitest Whites Rinse/Drain _Warm / Warm
y0h O
Controls Locked Clean _ Medium _Warm / Cold 2nd Rinse
Washer
Door Locked _ _L_Clo_¥ /O Low _Cold /Cold
De;ay Start
lObeS gNTI SIA_
0 0
Spin Wash / Rinse IOCKI J IOCKC_*'_-RO S
Speed Temp
Fire Hazard
Never pmace items in the washer that are dampened
with gaeomine or ether flammable fluids°
No washer can compietemy remove oil
Do not dry anything that has ever had any type of oH on
it (incmuding cooking oils).
Doing so can resumt in death, expmosion, or fire,
WARNING: To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance,
The following is a guide to using your washer. Please refer to
specific sections of this manual for more detailed information.
Do not store laundry additives on the top surface of this washer.
Vibration is normal during operation.
Use only High Efficiency detergents. The package for this type of
detergent will be marked "HE" or "High Efficiency." This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result
in washer errors, longer cycle times and reduced rinsing
performance. It may also result in component failures and
noticeable mold or mildew. HE detergents are made to produce
the right amount of suds for the best performance. Follow the
manufacturer's instructions to determine the amount of detergent
to use.
Use only HE High Efficiency detergent.
First Wash Cycle Without Laundry
Before washing clothes for the first time, if not completed during
the final installation step, choose the Normal/Casual cycle and
run it without clothes. Use only HE High Efficiency detergent. Use
1/2 the manufacturer's recommended amount for a medium-sized
load. This initial cycle serves to ensure the interior is clean before
washing clothes.
For All Wash Cycles
1.
2.
3,
4,
To load washer
Open the washer door by pulling on the handle.
Sort laundry according to color and type of fabric. Place a
load of sorted clothes in the washer. Do not overload washer.
Overloading can cause poor cleaning.
• The washer can be fully loaded, but not tightly packed.
Washer door should close easily.
• Mix large and small items. Avoid washing a single item.
Load evenly.
• Wash small items such as infant socks in mesh garment
bags. It is recommended that more than one garment bag
be used and that each garment bag be filled with equal
amounts of material.
• When unloading garments, occasionally check under the
gray colored seal/bellow rim at the front of the tub for
small items.
Close the washer door by pushing it firmly until the lock
clicks. The washer door will remain locked during the wash
cycle.
NOTE: After any wash cycle is completed, the door must be
opened and then closed before a new cycle can begin. The
door can be opened only if STOP is selected while the ADD A
GARMENT light is illuminating or if the cycle has been
canceled. See "To cancel a cycle" in the "Changing Cycles,
Options and Modifiers" section.
Open the dispenser drawer and add laundry additives to the
detergent, bleach, or fabric softener compartments. Close
drawer slowly to avoid spills. See "Using the Dispenser."
NOTE: Use only HE High Efficiency detergent.
Turn on the washer by selecting POWER. Select one of the
cycles by turning the cycle selector. The indicator light for the
selected cycle will illuminate. When selecting a Wash Cycle,
the preset Modifiers and Options, Water Temp, and Spin
Speed for the selected cycle will illuminate. The preset
settings provide the recommended fabric care for the
selected cycle. See "Cycles."
13