CLEANING
THE DEBRIS
FILTER
We recommend
cleaning the debris filter when water does not drain well or the "ND" error message is displayed.
to
Open the filter cover by pressing
and pulling the handle of the
filter cover with your finger.
2.
Unscrew
the drain cap by turning
it
counterclockwise.
3o Hold the cap on the end of the drain tube and
slowly pull it out about 6 inches (15 cm) and
drain off all the water.
Step
1
Step
2
4.
Remove the debris filter cap.
5. Wash any dirt or other material from the
debris filter. Make sure the drain pump
propeller
behind the debris filter is not
blocked.
6.
Replace the debris filter cap.
7.
Replace the filter cover.
CLEANING
THE DOOR SEAL/BELLOW
t.
Open the washer door and remove any clothing
or items from the washer.
2.
Inspect the gray colored
seal/bellow
between
the door
opening
and the basket for stained areas. Pull back the
seal/bellow
to inspect
all areas under the seal/bellow
and to
check for foreign objects.
3.
If stained areas are found, wipe down these areas of the seal/bellow, using the procedure that follows.
a)
Mix a dilute solution,
using % cup (177 mL) of liquid chlorine bleach,
and 1 gal. (3.8 L) of
warm tap water.
b) Wipe the seal/bellow
area with the dilute solution,
using a damp cloth.
c}
Let stand
5 minutes.
d}
Wipe down area thoroughly with a dry cloth and let the washer interior air dry with door open.
[_
IMPORTANT."
Wear rubber gloves when cleaning for prolonged
periods.
Refer to the bleach manufacturer's
instructions
for proper use.
PRESERVING
THE TOP COVER AND THE FRONT FRAME
Do not place any heavy or sharp objects or a detergent box on the washing machine. Keep them on the purchased
pedestal or in a separate storage box. This may scratch or damage the top cover of the washing machine.
[_
ince the entire washing
machine
has a high-gloss
finish, the surface
can be scratched
or damaged.
Therefore,
avoid scratching
or damaging
the surface when using the washing
machine.
maintaining
your washer 23