Setting Up The Nebulizer Compressor And Nebulizer Accessories - Drive PACIFICA 2 Manual Del Usuario

5. SETTING UP THE NEBULIZER COMPRESSOR AND NEBULIZER
ACCESSORIES
1. Wash hands with soap and warm water and dry completely with a clean towel.
2. Place the compressor on a clean, dust-free, stable and flat surface. Check the filter monthly or
every 10-12 treatments and replace if dirty, clogged, or wet to ensure proper operation.
Note: Tubing and accessories are NOT sterile from Package.
3. Make sure tubing and accessories have been cleaned and /or disinfected before first use and after last daily
treatment. Refer to the Cleaning and Disinfecting Tubing and Accessories section on page 12.
4. Remove the nebulizer cap by twisting counter-clockwise until it stops and lift up (Figure 3-1).
5. Fill nebulizer cup using eyedropper or syringe with prescribed medication. Do not fill more than 8 ml per
treatment (Figure 3-2).
6. Close the nebulizer cap and turn clockwise until it is tightened (Figure 3-3).
Figure 3-1 Figure 3-2
7
Figure 3-3