Miele SEB 228 Instrucciones De Manejo página 11

Illustrations
The illustrations referred to in the text
are shown at the end of these operat-
ing instructions.
Using the Electrobrush
The Electrobrush is driven by its own
motor.
It is very effective at removing deep
seated dirt and preventing areas of fre-
quent use being trodden into a path.
Two of the four rollers are height-ad-
justable, allowing you to adjust the gap
between the Electrobrush and the floor.
Recommended use

Please note that the Electrobrush
should not be used for vacuuming
deep-pile rugs and carpets or valu-
able hand-knotted rugs and carpets,
e.g. Persian and oriental rugs etc.
There is a danger of the threads be-
ing pulled out.
The Electrobrush is particularly suitable
for intensive vacuuming of carpets
which are subject to hard wear.
The standard floorhead or one of the
Miele floorbrushes should be used for
cleaning hard floors.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
Guide to the appliance (dia. 1)
 Release button
 Hose connection socket
 Foot switch for releasing the con-
nection socket
 Height display
 Foot switch for adjusting the
height
How to use the Electrobrush
 To achieve the best results, pass the
Electrobrush slowly backwards and
forwards over the carpet or floor.
For rugs and carpets with fringes al-
ways draw the Electrobrush from the
middle of the rug or carpet across the
fringe towards the floor.
Connect the Electrobrush to
the vacuum cleaner
 Connect the Electrobrush to the va-
cuum cleaner as illustrated.
– Electrobrush with cable: Dia. 2
– Electrobrush with direct connectors:
Dia. 3
Adjusting the height (dia. 4)
The Electrobrush has five settings for
adjusting the distance between the
Electrobrush and the floor. The display
shows the setting selected.
Setting 1 - closest to the floor
Setting 5 - furthest away from the floor
 Press the foot switch repeatedly until
the required setting is reached.
en
11