Handle Assembly; Assembly Instructions - Troy-Bilt TBE515 Manual Del Usuario

HANDLE ASSEMBLY

1. Remove the nuts and bolts from the handle components.
Be sure that they return to the holes they came out of.
2. Place the 2-holed end of the straight metal shaft over the
shaft base on the unit and align the holes (Fig. 1). Make
sure the TO START label is facing up.
3. Insert the two flange-head bolts (1/4" x 1-1/4") into these
holes (Fig. 1). Hand start the lock-nuts onto the flange-
head bolts.
4. Using a 3/8" wrench, hold each flange-head bolt and
tighten the lock-nuts with a 7/16" wrench until firm. DO
NOT OVERTIGHTEN.
5. Insert the control handle onto the 3-holed end of the
straight metal shaft and align the control handle's holes
with the two end holes of the straight metal shaft (Fig. 2).
Make sure the hex pockets are facing up.
NOTE: Because the control cables are pre-installed, care must
be taken when installing the control handle to not pinch or
bend the cables. This can damage them and cause them
to function improperly.
6. Insert the two screws (1/4" x 1-1/2") into the recessed hex
holes on the handle (Fig. 2) and hold in place.
7. Hand-start the lock-nuts onto these bolts.
8. Using a 7/16" wrench, tighten each nut onto each bolt until
firm.
9. Pull out the starter rope and run it into the eye hook (Fig. 3).
10. Insert the eye hook into the remaining hole on the straight
metal shaft (Fig. 3).
11. Screw the nut onto the eye hook (Fig 3) and use a 7/16"
wrench to tighten. DO NOT OVERTIGHTEN.
12. Using the zip ties in the hardware bag, secure the handle
cables to the straight metal shaft mid-way between the eye
hook and the motor housing and to the recessed groove on
the back of the handle.
NOTE: DO NOT run the control wires though the eye hook.

ASSEMBLY INSTRUCTIONS

Lock-Nuts
Lock-Nut
Flange-Head
Bolts
Lock-Nuts
Fig. 1
Starter Rope Handle
Fig. 3
Bolts
Fig. 2
Eye Hook
Starter Rope
5