Filling The Water Tank - Reliable VERVE 100SR Manual De Instrucciones

FILLING THE WATER
TANK
The Remaining Water LED illuminates blue if
there is no water, or if there is only 10% water in
the water tank. The water tank must now be filled
before any further steam ironing is done.
SWITCH OFF THE POWER AND UNPLUG THE MACHINE.
1. Pull upward on the cap of the filler opening. The lime descaling cartridge is in the filler
opening.
2. Remove the lime decaling cartridge. You may need to loosen the cartridge by a side-
ways movement (wiggle it). Then, turn the cartridge clockwise while pulling it upwards
3. Slowly fill with water up to the bottom of the filler opening (see illustration). Do not fill
with hot water. For the water level indicator to function properly, after the Remaining
Water LED indicator has illuminated, top up with at least 10 ounces (0.3 liters). Total
tank capacity is 2.74 pints (1.3 liters) with a descaling cartridge. The total tank capacity
is 2.95 pints (1.4 liters) without a descaling cartridge.
4. Replace the lime descaling cartridge and press the cap onto the filler opening.
Note: The filler opening must always be kept closed to prevent the water supply from
becoming contaminated. There is a delay in the steam development after an empty water
tank has been filled or if a new descaling granulate cartridge has been inserted.
11