Stopping The Water Pump - Briggs & Stratton ELITE Serie Manual Del Propietário

Stopping the Water Pump

1. Move engine speed lever to "Slow" (
(Figure 13).
2. Push on/off switch to "Off" position (Figure 13).
3. Turn white fuel valve to "Off" position (Figure 12).
CAUTION
DO NOT stop engine by moving choke lever to "Choke"
position. Backfire, fire or engine damage could occur.
Drain and Flush Water Pump
1. Disconnect and drain suction and discharge hoses.
2. Remove drain plug at bottom of pump (Figure 15).
Figure 15 — Remove Drain Plug
3. Remove plug from top of pump and flush internal
components of pump with clean water (Figure 16).
) position
Figure 16 — Remove Plug from Top of Pump and Flush
4. Replace both plugs and finger tighten.
14
OPERATION