Continuous Drainage - Whirlpool DE 20 LWS0 Manual Del Usuario

CONTINUOUS DRAINAGE

The appliance is connected to a drain outlet . The customer can purchase a drainage hose with 14 mm inner diameter and mount
it on the drainage adapter (8, inside the documentation bag) to drain condensate water . When assembling the continuous
drainage equipment, switch the unit off and pull out the power plug .
5
7
6 8
22
2. Draining the water
► If the water bucket is extracted during operation or immediately after turning off the
machine, water may drip onto the base . Therefore, wait for 3 minutes after stopping the
machine to extract the water bucket (if water has already dripped, clean the machine) .
3. Re-inserting the water bucket
► Insert the water bucket properly back into the machine . If the water bucket is not
properly positioned, the Water Full indicator will light up and the machine will not work .
1. Open the cover plate (5) (continuous drainage) and remove the drainage plug (7)
along the direction of the arrow, as shown below.
► Do not lose the drainage plug (7), otherwise water may leak out when using the water
bucket to collect water .
2. Remove the drainage plug (7) then turn the drainage adapter (8) in the continuous
drainage outlet (6) in the clockwise direction.
► Remarks: after removing the drainage plug (7) in the counter-clockwise direction, some
residual condensate water will be present . Use a container to collect the water .
► Pull the drainage adapter (8) through the continuous drainage outlet (6), then turn
it tightly clockwise into the unit's drainage outlet . Check whether the seal is in good
condition .
3. Insert the drainage hose in the drainage outlet (6).
► Insert the drainage hose into the drainage outlet (6) and ensure that no water leaks out .
The horizontal height of drainage hose should not exceed the height of the drainage
outlet . Place the dehumidifier on a level surface and avoid blocking the drainage outlet
make sure that the condensate water can be drained out easily (as shown in the figure
below) . Check the drainage adapter and drainage hose periodically to verify whether
they are tightly connected and whether they are damaged or blocked . Placing the
appliance on an uneven surface or improper hose installation may lead to water filling
the bucket causing the unit to switch off . Should this occur, empty the water bucket then
check the dehumidifier's location and the hose for proper set-up .
Use & Care Guide
NOTE:
For continuous water drainage be
careful not to bend the hose and
to position its nozzle below the
appliance . Otherwise water may spill
and damage household objects .