Velleman MONCOLHA3 Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

to the reverse gear power circuit. Make sure there is no power on the
connection wire (remove fuse).Connect the backing-up camera to video
input AV2.
• Apply power to the system (re-insert fuses). The status indication [F]
should light up.
• The sun shade [A] can be removed by sliding it upwards.
7.
Use
• Switch on the monitor by pressing the ON/OFF button on the monitor [C]
or remote control [I]. Note that when connection to the reverse gear
system is made, the monitor switches on automatically when reverse
gear is selected.
• Select the video channel (AV1 or AV2) by pressing the video select button
on the monitor [D] or remote control [J].
• Press the mode select button on the monitor [E] or remote control [M] to
select monitor setup presets: STANDARD – SOFT – VIVID – LIGHT.
• Press the menu button [K] on the remote control to enter manual
monitor setup. Use the video select [J] and mode select [M] to navigate
through the settings; use the increase [L] or decrease [N] buttons to
change the settings.
• Brightness, contrast and colour can be set between 0 and 32.
• To select system setup, go to RESET and press the menu button [K]. The
system menu is displayed.
BLUE
ON, OFF
VIDEO
AV1, AV2
30S, 1MIN, 3MIN,
BLUEOFF
5MIN, OFF
• Press on the menu button [K] again to exit the manual monitor setup.
00
(07/11/2008)
MONCOLHA3
Select ON to display a blue screen when no
video signal is detected.
Select which video input is used for backing up
camera (default: AV2)
Monitor switches off automatically after set
time when no input signal is detected. OFF
disables this function.
5
®
Velleman

Publicidad

Tabla de contenido
loading

Tabla de contenido