Oregon PowerNow CS250 Manual Del Operador página 5

orEgoN® powerNow™
ChAiNsAW MoDEl Cs 250
general safety rules –
personal safety
• Stay alert, watch what you are
doing and use common sense when
operating the chainsaw. Do not use
the chainsaw while you are tired or
under the influence of drugs, alcohol,
or medication. A moment of inattention
while operating the chainsaw may result
in serious personal injury.
• Use personal protective equipment.
Always wear eye protection. Protective
equipment such as a dust mask, non-
skid safety shoes, hard hat, or hearing
protection used for appropriate
conditions will reduce personal injuries.
Never wear shorts when operating the
chainsaw. Always wear long pants or
chaps.
• Dress properly. Do not wear loose
clothing or jewelry. Keep hair, clothing,
and gloves away from moving parts.
Loose clothes, jewelry, or long hair can
be caught in moving parts.
• Prevent unintentional starting. Make
sure the trigger switch is in the off
position and the trigger lock-out is not
pressed before connecting to power
source and/or battery pack, picking
up, or carrying the tool. Carrying the
chainsaw with finger on the trigger
switch invites accidents.
• The work piece, bar, and chain can be
hot after cutting. Wear gloves to avoid
burns.
• Remove any adjusting tool before
operating the chainsaw. A tool left
attached to or near a rotating part of
the chainsaw may result in personal
injury.
AF 0911 - F/N 547361
• Use two hands when operating the
chainsaw.
• Do not overreach (Fig. 1). Keep proper
footing and balance at all times. This
enables better control of the chainsaw
in unexpected situations.
Fig. 1
• Use proper auxiliary equipment and
ensure that it is not damaged, of
adequate strength, and securely placed.
Use auxiliary equipment only for the
purpose for which it is intended.
• Prolonged use of power tools has been
reported to cause vascular, muscular, or
neurological disorders. To reduce the
risk of injury, follow these instructions:
– Wears gloves and keep hands and
body warm.
– Maintain a firm grip on the
chainsaw, but do not use
prolonged, excessive pressure.
– Take frequent breaks.
general safety rules –
poWer tool use and care
• Do not force the chainsaw. Use light
pressure when cutting.
• Use the chainsaw only for the purpose it
was intended.
• Do not use the chainsaw if the trigger
switch does not turn it on and off. Any
power tool that cannot be controlled
with the trigger switch is dangerous and
must be repaired.
• Disconnect the battery pack from
SAFETY RULES
5