To Attach Pasta Pressaccessory; To Use Pasta Pressaccessory - KitchenAid KPEXTA Instrucciones Y Recetas

To Attach Pasta Press Accessory
Before Attaching Pasta Press
Accessory
Remove "Do not immerse in water" label,
and detach the storage case from the
accessory housing top.
To Attach:
1. Turn Stand Mixer speed control to OFR
2. Unplug Stand Mixer or disconnect
power.
3. Loosen the accessory knob (P) by
turning it counterclockwise.
4. Remove the accessory hub cover or flip
up hub cover.
5. Insert the accessory shaft housing (N)
into the accessory hub (0) making
certain that accessory power shaft fits
into square hub socket.
6. It may be necessary to rotate the
accessory back and forth. When the
accessory is in proper position, the pin
on the accessory housing will fit into
the notch on the hub rim.
7. Tighten the accessory knob by turning
it clockwise until the accessory is
completely secured to Stand Mixer.
iiiiiiiii!
N 0
To Use Pasta Press Accessory
Rotating Blade Hazard
Always use food pusher.
Keep fingers out of openings.
Keep away from children.
Failure to do so can result in
amputations or cuts.
2. Slowly feed walnut-size pieces of
dough into the hopper; dough should
self-feed. The auger should be visible
before adding the next piece of dough.
i
3. Use combo tool to push dough only if
dough becomes caught in hopper and
no longer self feeds.
1,
Set the Stand Mixer speed between
6 and 10, according to pasta type
and personal preference. For best
results, Fusilli should be extruded at a
maximum speed of 6. Slower speeds
are also recommended for very short
pasta. Longer pasta, such as Spaghetti
may be extruded at higher speeds.