Important - Briggs & Stratton 030253 Manual Del Operario

2. Turn the fuel shut off valve to the "Off" position
(Figure 5).
Figure 5 — Fuel Shut-off Valve
Fuel Valve is shown
in the "Off" position
3. Disconnect the quick connect on the fuel line by
pushing on the metal tab and twisting apart (Figure 6).
Release the metal tab. Some fuel that is left in the line
will spill out.
Figure 6 — Quick Connect
4. Remove the four large plastic wing nuts holding the
tank onto the frame by turning them counter-
clockwise (Figure 7).
Figure 7 — Plastic Tank Wing Nuts
Fuel Tank
8
5. Lift off the fuel tank by grasping the handle (provided
on the tank) with one hand and putting the other hand
in the finger pocket (Figure 8). Lift the tank straight up.
Figure 8 — Lifting Off Fuel Tank
IMPORTANT:The fuel tank MUST be filled with it lying
flat, not slanted or standing upright (Figure 9). DO NOT let
the fuel valve and quick connect come in contact with any
dirt.
Figure 9 — Fuel Tank
To place the fuel tank back on the unit, follow these same
steps in reverse order. Make sure the four large plastic wing
nuts are tightened securely.
IMPORTANT: Remove any dirt found inside the quick
connect before putting the fuel tank back on the unit.
Make sure the vent knob is turned fully counter-
clockwise to open it. If you don't open it, fuel will not
flow into the fuel line causing the unit to not start.
ASSEMBLY