Triton ABA020 Instrucciones De Uso página 5

e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
ASSEMBLY
Fitting the Base Bracket
1. Loosely fit the Base Bracket (A) onto the slide chassis,
as in Fig 1, so that its vertical section is in line with or
just clear of the end of the saw's motor housing.
2. Use two of the ¼" x ½" Coach Bolts (I), Spring
Washers (K) and ¼" Nuts (J), and finger tighten only.
Fitting the Pivot Mounting Bracket
1. Loosely attach the Pivot Mounting Bracket (B) to the
Base Bracket (A) using the remaining ¼" x ½" Coach
Bolt (I), a Spring Washer (K) and a ¼" Nut (J). Again,
finger tighten only.
NOTE: Fig 2 shows the way in which the bracket is
attached, but the exact position of the bracket is
determined in the next steps.
2. Loosely fit the pivot bolt assembly - consisting of a ¼"
x ¾" Coach Bolt (H), the ¾" x 5/16" Flat Washer (M),
Spring Washer (K) and ¼" Nut (J) - into the slot of the
Pivot Mounting Bracket (B) as shown in Fig 2.
NOTE: Do not yet fit Slotted Strap (C) and Nyloc Nut (L)
shown in Fig 2.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
3. The next step is to ensure that this pivot bolt assembly
is in line with the saw's front pivot, both vertically and
horizontally. This will enable you to change the saw
Fig: 1
blade height without having to change the stabilising
bracket setting.
NOTE: Fig 3 shows the pivot bolt set in line with the
saw's front pivot. It is possible to achieve this by
carefully lining up by eye, but it is preferable to
measure the relative pivot points from your slide plate,
as shown, using a ruler or measuring tape.
Safety Instructions / Assembly
Fig: 2
GB
Fig: 3
5