Cooling Off mode (also called Shop mode),
is designed for use by retailers when they
are displaying refrigerators on the shop
floor. In Cooling Off mode, the refrigerator's
fan motor and lights work normally, but the
compressors do not run, and the refrigerator
and freezer do not get cold.
To start Cooling Off mode, touch and hold
the Energy Saver button and the Power
Freeze button for 5 seconds during normal
operation. The refrigerator chime sounds and
the temperature display flashes OF OF.
To cancel Cooling Off mode, touch and hold
the Energy Saver and the Power Freeze
buttons again for 5 seconds.
If you don't want to make more ice, touch
the Ice Off button.
The icon will light up and the Ice-Maker
stops making ice.
We recommend
you stop ice making
if the following occur:
- There is enough ice in the ice
bucket.
- You want to save water and energy.
- Water is not being supplied to the
refrigerator.
lf the ice maker function is ON, and
the water Line is not connected, there
will be a water valve noise from the
back of the unit, press the Ice Off
(Hold 3sec for child lock) button for
less than 3 seconds until the Ice Off
Indicator (_) illuminates.
If you do not press any button(letters
not ICON), the
display turns off in a few seconds.
If you press any button(letters
not ICON), the
display lights up again.
The function
key will operate
after
you remove
your finger
from
the letters
except
E.Saver,
Ice
and Water
key.
Water
filter
usage
This icon will light up when you need to
change the filter. After you use about 300
gallons of water, the filter indicator lights
up. (about 6 months). After you install the
new water filter, reset the filter indicator
by touching the Alarm/hold 3 sec for Filter
Reset button.
, If water is not dispensing or
dispensing slowly, you need to
replace the water filter because the
water filter is clogged.
• Some areas have large amounts of
lime in their water, which causes the
water filter to clog more quickly.
CHANGING
THE WATER FILTER
Z_
To reduce risk of water damage
to your
WARNING property DO NOT use generic brands of
water filters in your SAMSUNG
Refrigerator.
USE ONLY SAMSUNG
BRAND WATER FILTER.
SAMSUNG
will not be legally responsible
for any
damage,
including, but not limited to property
damage
caused by water leakage from use of a generic water
filter. SAMSUNG
Refrigerators
are designed
to work
ONLY WITH SAMSUNG
Water Filter.
The Filter light turns red to let you know when
it is time to change your water filter cartridge.
To give you time to get a new filter, the red
light comes on just before the capacity of the
current filter runs out. Changing
the filter on
time provides you with the freshest,
cleanest
water from your refrigerator.
(Red)
1. Shut off the water supply. Then, turn the water filter
( 1 ) about 1/4 turn, counter-clockwise.
2. Pull the water filter ( 1 ) from the case filter ( 2 ).
,!I u
,
o change the water filter more easily, shut off
the water supply valve.
,, Sometimes,
it is hard to disassemble
the water
filter because impurities
in the water cause it to
stick. If you are having difficulties,
grip the water
filter firmly and pull it hard.
,, When you pull the water
filter, a little water can
leak from the opening.
This is normal. To
minimize the water
leaks, keep the filter
cartridge
horizontal when you pull it.
,, To prevent overflow,
empty the water filter tray
( 3 ) and dry around the filter case ( 2 ).
3. Insert the new filter into the filter case ( 4 ).
4. Push the filter, and then turn it clockwise
until it
locks.
%
®
, f you have trouble
inserting the water filter
because of high water pressure,
shut off the
water supply valve.
DA68-02488A-09.indb
12
13. 4. 25.
DD 2:08