Kit Components; At-6010-R Receiver - Ampro AT-6010 Serie Manual De Usuario

2. KIT COMPONENTS

2.1 AT-6010-R Receiver

The AT-6010-R Receiver detects the signal in wires and cables. The signal is generated by the AT-
6010-T Transmitter, which is connected to the wire.
The main advantage of this method is the ability to trace the path of the particular wire using
the Receiver. Since the signal is not present in any neighboring wires, the Receiver will
detect only the wire that is connected to the Transmitter.
Note: The Receiver will NOT detect signals from a wire through metal conduit or shielded cable. Refer
to Special Applications, section 4.4 "Tracing Wires In Metal Conduit" for alternative tracing methods.
TIP SENSOR
TACTILE
BARRIER
VOLUME
ADJUSTMENT
BUTTON (+/-)
RUBBER OVER
MOLDED
ENCLOSURE
SENSITIVITY
ADJUSTMENT
BUTTON (+/-)
POWER BUTTON
BATTERY
COMPARTMENT
(Back side)
POWER BUTTON: Short press to turn the Receiver on. Long press >2s to turn the Receiver off.
VOLUME ADJUSTMENT: The volume can be changed by short presses on the volume +/- buttons.
The mute and four loudness level are available. The chosen volume level will be shown on the display.
TIP SENSOR: The LED on the Tip Sensor will blink when a signal is detected. The stronger the
signal, the faster the blinking.
SENSITIVITY: Press +/- buttons to adjust the sensitivity of the Receiver. Eight levels are available.
Figure 2.1: Overview of AT-6010-R Receiver
SOUND
VOLUME
5
ENERGIZED/
DE-ENERGIZED
BATTERY STATUS
SIGNAL
STRENGTH (0-99)
SENSITIVITY
LEVEL (1-8)
BARGRAPH -
proportional to
signal strength