Access Restrictions - EGi MILLENIUM 1202 Manual Del Usuario

Control console. Basic operation
9 Making a call when any of the targeted zones
is in "private" mode
If three groups -for instance- have been previously
created:
GR 01 (And then the sign "<" appears next to
GR 01) +
If, in the selected group, any of the zones is in
"private" mode:
If, instead of a group, a zone had been selected
which was in "private" mode, the name given to that
zone would appear in the screen.
yES will send the message to the whole group.
NO will send the message only to the zones of the
selected group which are not in "private" mode.
1202
As long as we keep the button pressed,
what is said to the microphone will be broadcast in
all the selected zones.
It is also possible to select several groups or zones,
or even a combination of groups and zones -taking
into account that if we enter a group to select some
of its zones, the selection of that group (as a whole
unit) will automatically be cancelled-.
If the paging line is busy because another call
is being broadcast or a pre-recorded message
is being played or saved from another console
1202, instead of the last two screens, the following
message will appear:
Control console. Access restrictions
1 Enabling and disabling the general access
password
If three groups -for instance- have been previously
created:
SETUP
Provided that there is NEITHER a pre-recorded
message player (1103) NOR a module for sending
messages over the telephone (1104) in the
system:
MORE
PASSWORD
NO disables the general access password.
1+ 2+ 3+ 4+ will turn on the led lamp
next to yES.
If then we press YES then the code 1234 has
been enabled as general access password.
The 4 bottom keys ; ; SETUP and
act here as numeric keys.
1202
2 Entering the general access password
If the general access password is active, whenever
we want to access to the advanced functions of the
system, the module for sending messages over the
telephone, or the pre-recorded message player, a
password will be required by the following screen:
SETUP and
The 4 bottom keys ; ;
act here as numeric keys.
If we make a mistake when entering the password,
it is possible to start again by pressing ERASE.
For each entered digit, a " – " symbol will be
substituted by a " * " symbol.
29.