EGi MILLENIUM 1202 Manual Del Usuario página 36

Control console. Operation of the pre-recorded message player
36.
5 Replay of a message
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is
NOT active, and there is a pre-recorded message
player (1103) in the system but NOT a module for
sending messages over the telephone (1104):
MESSAGE
MSG. 5
REPEAT
Provided that message number 5 is already
recorded:
+ + +
INTERVAL
+
+ programs message 5 to be played
2 times, with an interval of 1 minute between 2
repeats.
1202
If the general access password is active the system will require us to introduce it every
time we try to operate this module (see point 2 of "Access restrictions").
6 Changing the volume level of a message
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is
NOT active, and there is a pre-recorded message
player (1103) in the system but NOT a module for
sending messages over the telephone (1104):
MESSAGE MSG. 6
MORE VOLUME
+ or – modifies the volume level of the
message. If reduced to 0, the message will be
played in each target zone at the volume level that
is set for paging there.
7 Monitoring a message
If three groups -for instance- have been previously
created:
SETUP
Provided that the general access password is
NOT active, and there is a pre-recorded message
player (1103) in the system but NOT a module for
sending messages over the telephone (1104):
MESSAGE MSG. 7
MORE
MONITOR plays the message number 7 (if
previously recorded) by the built-in speaker at the
control console 1202. If the paging line is busy
because another message is being broadcast or
a pre-recorded message is being played or saved
from another console 1202, instead of playing the
message the following message will appear: