GB
6
Switch the motor off by turning the switch to "OFF".
Note: Always wait for the motor to come to a complete stop before removing the lid.
CLEANING AND MAINTENANCE
It is important to keep the appliance clean and in good working order to ensure optimum quality of
the products and long life of the appliance.
To clean the appliance, unplug the appliance and clean with a damp cloth or alcohol, or use
a generic spray detergent.
Dry with a dry cloth.
Never wash the appliance with jets of water or immerse the motor housing.
Do not expose the lid to temperatures above 60°C. This would damage the magnetic
sensor.
TROUBLESHOOTING
In case of any malfunction, defect of the appliance or if you suspect any breakage after a fall, unplug
the appliance immediately.
If you are unable to solve the problem referring to the table below, contact an Authorized Service
Center.
Only qualified experts should repair the appliance.
We are not liable for any damage caused by repairs not made correctly by unauthorized personnel.
In these cases the warranty does not apply.
Problem
The ice crusher does not
start.
•
Make sure it is plugged in.
•
Make sure the safety circuit breaker is closed.
•
Make sure the magnetic sensor in the lid is in the correct
position.
•
Make sure the switch on the appliance is turned to ON.
•
If the problem occurs after a long period of intensive use the
motor may have overheated. Wait at least 20 minutes and try
again. If you put the appliance in a cool place this will reduce
the waiting time.
•
If the problem occurs after an overload, the circuit breaker on
the motor may have been tripped! Push the button on the
back or bottom of the appliance (not standard equipment on
all models).
Solution
43