Optika Italy B-500 MET Manual De Instrucciones página 7

3.0 UNPACKING AND ASSEMBLY
3.4 Place the observation head into the top of the attachment and tighten the lock-screw.
3.5 Insert the eyepieces into the eye tubes.
3.6 Insert polarizer and analyzer filters into their slots in the metallographic attachment.
3.7 Connect the power cable of the epillumination to the appropriate connector on the rear.
Connect the mains plug into the socket at the base
Make sure, before you turn the illumination on, that the voltage selector is set to the mains
voltage for your region.
The power cord should be used only on network sockets equipped with adequate grounding.
Contact a technician to check the state of your electrical system. If there is no need to install
additional accessories, the instrument is now ready for use. Once positioned and installed
with the necessary components, the microscope is ready to be used. Your microscope is a
laboratory instrument designed to last. Handle it always carefully and avoid abrupt vibrations
or shocks. Always disconnect the power cable from the microscope when not in use for long
time, while you clean it or when you perform any maintenance.
AVOID DISASSEMBLING THE INSTRUMENT
Do not disassemble the instrument. This entails the cancellation of the warranty and may
cause malfunction.
Page 7