Makita 3706 Manual De Instrucciones página 6

When inserting the drywall guide bit into the drywall,
carefully insert the bit straight until the shoe base is in full
contact with the material.
004972
Move the tool slowly with a constant pressure in a
clockwise direction to make the cut.
When cutting straight line, clamp a straight board firmly
to the material and use it as a guide. Move the tool in the
direction of the arrow with the shoe base flush with the
side of the guide board.
001630
When the cut is complete, turn the tool off and wait for the
bit to stop rotating and then carefully remove it from the
material.
NOTE:
1. When using this tool, the rotating action causes
the tool to pull. The less pressure applied to the
tool causes less pull and provides a more accurate
cut. Excessive pressure or fast cutting can cause
the bit to dull or break premature.
2. When cutting drywall around outlet boxes, cut in a
counterclockwise direction for ease of cut.
3. The standard bit included with this tool is for cutting
drywall only. When cutting materials other than
drywall, do not use the standard drywall guide bit.
Circular guide
Circular cutting diameters: 10 cm (4") - 34 cm (13-3/8")
Installing circular guide
2 3
1
004973
Release the thumb screw which serves to secure the shoe.
Align the projections in the circular guide with the
grooves in the shoe, and secure the shoe and circular
guide using the thumb screw.
2
3
1
004974
To adjust the cutting depth, proceed first by loosening the
thumb screw and then by sliding the shoe and circular
guide together. After completion of the adjustment,
tighten the thumb screw securely.
1
001633
OPERATION
3
2
001634
Loosen the knob, and adjust its position in accordance
with the size of the circle to be cut. (The hole dimensions
to be cut are indicated on the side of the circular guide as
a general guideline.) After completion of the adjustment,
tighten the knob securely.
6
1. Shoe
4
2. Loosen
3. Tighten
4. Thumb screw
1. Shoe
2. Circular guide
3. Projections
2
1. Shoe
2. Circular guide
3. Thumb screw
3
1. Knob
2. Tighten
1
3. Loosen