Ryobi P212G Manual Del Operador página 9

Taladro de percusión compacto de 18 v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
Do not hold the chuck body with one hand and use the
power of the drill to tighten the chuck jaws on the drill
bit. The chuck body could slip in your hand, or your
hand could slip and come in contact with the rotating
drill bit. This could cause an accident resulting in serious
personal injury.
TWO-SPEED GEAR TRAIN
See Figure 6, page 14.
The drill has a two-speed gear train designed for drilling or
driving at LO (1) or HI (2) speeds. A slide switch is located on
top of the drill to select either LO (1) or HI (2) speed. When
using drill in the LO (1) speed range, speed will decrease
and unit will have more power and torque. When using drill in
the HI (2) speed range, speed will increase and unit will have
less power and torque. Use LO (1) speed for high power
and torque applications and HI (2) speed for fast drilling or
driving applications.
NOTE: If you have difficulty changing from one gear range to
the other, turn the chuck by hand until the gears engage.
1. APPLICATION
• Lag screws up to 3/8 in. dia. by 1-1/2 in. long
• Hole saw up to 2 in.
• Spade bits up to 1-1/2 in.
• Drill bits up to 1/2 in.
• Drilling into metal
• Concrete screws
• Deck or wood screws up to 3 in.
• Self tapping screws
• Deck or wood screws up to 2 in.
• Small screws or delicate work that requires more control
• Drilling into masonary and concrete.
OPERATION
CAUTION:
Never change gears while the tool is running. Failure to
obey this caution could result in serious damage to the
drill.
QUICK MODE SELECTOR
See Figures 7 - 8, page 14.
The Quick Mode Selector allows you to quickly switch from
drill mode to drive mode.
In general, drill mode should be used for drilling and other
heavy duty applications. Drive mode should be used for
driving screws. Hammer mode should be used for hammer
drilling.
SELECTING DRIvE OR DRILL SETTING
See Figure 8, page 14.
Using the chart , select the option that best matches the type
of bit, fastener, and material you will be using.
1. Choose your APPLICATION.
2. Choose the correct SPEED: (1/LOW OR 2/HIGH)
3. Choose the correct MODE: (DRIvE, DRILL, OR
HAMMER)
2. SPEED
2/HIGH
9 — English
3. MODE
DRILL MODE
1/LOW
(TORQUE ADJUSTMENT
NOT ACTIvE)
2/HIGH
DRIvE MODE
1/LOW
2/HIGH
HAMMER MODE
1/LOW
(TORQUE ADJUSTMENT
NOT ACTIvE)

Publicidad

Tabla de contenido
loading

Tabla de contenido