Panasonic CQ-C7413U Manual De Instrucciones página 19

The equalizer curve is selectable from among preset 6
types (FLAT, ROCK, POP, VOCAL, JAZZ, and CLUB)
depending on your listening category.
Note: SQ is not changeable when SRS WOW is enabled.
(a page 18)
SQ changeover
The SQ category is changed every time [SQ] (Sound
Quality) is pressed.
Note: Setting of SQ, bass/treble and volume are
influenced one another. If the influence mentioned above
causes distortion to the audio signal, readjust bass/treble
or volume. (a page 28)
SQ is adjustable in accordance with your taste.
1
Hold down [SQ] (Sound Quality) for 2 sec.
or more when SRS WOW is disabled.
2
Press [BAND].
The targeted SQ preset appears.
3
Adjust each band.
¡ CQ-C7413U (SQ7)
Band: 60, 160, 400, 1 k, 3 k, 6 k, 16 k (Hz)
[]] [[]: Band selection
[}] [{]: Level up/down
¡ CQ-C7113U (SQ3)
Band: 60, 1 k, 10 k (Hz) (default)
Only for CQ-C7413U
The rear speaker can be used as a substitutional sub-
woofer when a subwoofer is not connected.
Holding down [MUTE] (SBC-SW) for 2 sec.
or more toggles SBC-SW on and off.
Off (default)
Lights when activated.
[]] [[]: Band selection
[}] [{]: Level up/down
q / w: center frequency up/down
4
Press [BAND] to determine
the adjustment.
The screen of Step 1 appears again.
5
Press [D] (DISP).
The regular screen appears again. "USER" appears in
the category name after adjustment.
Note: If you hold down [BAND] for 2 sec. or more
on the SQ call-up screen, the presetting that is called
up can be turned into the default.
Lights when
activated.
Notes:
If ON is selected, the settings of subwoofer level
¡
adjustment and subwoofer low pass filter are activat-
ed. (a page 28)
On
¡ SBC-SW is not changeable when SRS WOW is
enabled. (a page 18)
CQ-C7413U/C7113U
19