Beper BP.730 Manual De Instrucciones página 14

Electric Meat Grinder With Tomato Juicer Use instructions
WARNINGS OF USE
The meat grinder should only be used for domestic use.
In case of failure and / or malfunctioning of the meat grinder, do not use it, turn it off and not
tamper with it.
Before each use check the integrity of the power cord and make it free it from any tangles.
To turn the power on or off use the appropriate buttons, do not do it by insert or remove the plug
from the power socket.
Always unplug the appliance from the power outlet before installing or removing moving parts and
after use and before cleaning it.
Place the meat grinder on a horizontal and stable surface.
Do not leave the meat grinder unattended. Before leaving the room, check that it is off and discon-
nected from the socket.
Do not transport the appliance by grasping it from the tray or cutting unit.
Always use the supplied food pusher. Never use other tools or fingers for this purpose.
This meat grinder is not suitable for chopping hard foods like nuts, bones, etc.
Do not use to grind foods containing hard or rigid fibers such as ginger.
Do not use the meat grinder for more than five continuous minutes and in any case allow the engine
to rest for about five minutes after each use.
To avoid clogging, do not exert excessive pressure with the food pusher.
The blade is sharp, handle it with care both during use and cleaning.
Do not attach the blade and the hopper plate when using the Kibbe accessory.
After use, residues of meat may remain between the blade and the closing ring. Do not use this
meat at all.
Before using the product for the first time, please clean each component following the instructions
as indicated in the specific paragraph.
The use of the reverse function that can be operated with the REVERSE button should not be used
while the product is operating, always wait for the product to stop.
ASSEMBLING (FIG.1-6)
Press the fasten button hold the head and insert it into the inlet turning on the right.
Move the head anticlockwise so that the head being fastened tightly.
Place the snake into the head, long end first, and turn to feed the screw slightly until it is set into the
motor housing.
Place the cutting blade onto the snake shaft with the blade facing the front as illustrated. If it is not
fitted properly, meat will not be grinded.
Place the desired cutting plate next to the cutting blade, fitting protrusions in the slot.
Press the centre of the cutting plate with one finger then screw the fixing ring tight with another hand.
Do not over tighten.
Place the hopper plate on the head and fix it into position.
Locate the unit on a flat and stable place.
!ATTENTION! The air outlet placed on the bottom of the motor housing should be kept free
and not blocked
14