Tabla De Contenido; Description; Safety; Purpose Of This Manual - Greenlee 7309SB Manual De Instrucciones

Table of Contents
Description ..................................................................... 2
Safety ............................................................................. 2
Purpose of this Manual .................................................. 2
Important Safety Information ..................................... 3-4
Punch, Die, and Drawstud Selection .............................. 5

Description

Greenlee punches are cutting tools for punching holes
in a variety of materials and material thicknesses. These
punches are intended to be used with Greenlee dies,
drawstuds, and knockout drivers.
These punches are designed to be used with the
following Greenlee tools:
• Intelli-PUNCH™ Battery-Hydraulic Knockout Driver
• LS50L2 Battery-Hydraulic Knockout Driver
• Quick Draw Hydraulic Drivers
®
• 746A Hydraulic Driver
Standard and Slug-Buster punches can punch holes
through mild steel, brass, copper, aluminum, fiberglass,
and plastics, with limited stainless steel capability.
Do not exceed the rated capacity of the punch.
Driver and punch capacity ratings can differ. Ensure
your hydraulic driver meets capacity ratings before
attempting to punch a hole.
Greenlee Tools, Inc.

Safety

Safety is essential in the use and maintenance of
Greenlee tools and equipment. This manual and any
markings on tools provide information for avoiding
hazards and unsafe practices related to the use of the
tools. Observe all of the safety information provided.

Purpose of this Manual

This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
following Greenlee tool:
Keep this manual available to all personnel.
Replacement manuals are available upon request at
no charge at www.greenlee.com.
All specifications are nominal and may change as design
improvements occur. Greenlee Tools, Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
Quick Draw and Slug-Buster are registered trademarks of
Greenlee Tools, Inc.
KEEP THIS MANUAL
2
Punches for Hydraulic Tool Use
Punches for Hydraulic Tool Use
Do not discard this product or throw away!
For recycling information, go to www.greenlee.com.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070