Maintenance - Greenlee Quick Draw Manual De Instrucciones

Maintenance

Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Skin injection hazard:
Do not use hands to check for oil
leaks. Oil under pressure easily
punctures skin. If injured, seek
medical attention immediately to
remove oil.
Failure to observe this warning
could result in serious injury, gan-
grene, or death.
Do not use solvents or flammable
liquids to clean the tool body.
Solvents or flammable liquids could
ignite and cause serious injury or
property damage.
Pinch points:
Keep hands away from the tool
head when punching.
Failure to observe these warnings
could result in severe injury or death.
Relief valve adjustments must be done by an
authorized service center.
Greenlee Tools, Inc.
Quick Draw Hydraulic Knockout Drivers
®
Daily
Before use:
1. Inspect the tool for wear or damage, such as cracks,
gouges, or chips.
2. Inspect the tool for damage or leaks.
3. Inspect the rotation of the head assembly. Fully
return the ram. The head should rotate freely. If
damage is detected, contact Greenlee customer
service at 800-435-0786 for warranty service or
repair.
After use:
1. Use a damp cloth and mild detergent to clean the
housing. Allow the housing to dry.
2. Fully return the ram. Place the tool in the carrying
case and store in a cool, dry place.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070