Tabla De Contenido; Description; Safety; Purpose Of This Manual - Greenlee Quick Draw Manual De Instrucciones

Table of Contents
Description ..................................................................... 2
Safety ............................................................................. 2
Purpose of this Manual .................................................. 2
Important Safety Information ..................................... 3-5
Identification and Illustration .......................................... 6
Specifications ................................................................. 6
Setup and Operation .................................................. 7-8
Capacity ......................................................................... 9
Maintenance ................................................................. 10
Troubleshooting ............................................................ 11

Description

The Greenlee Quick Draw
are hand-held, self-contained punch drivers intended to
be used with Greenlee punches, dies, and drawstuds
for punching holes through mild steel, stainless steel,
brass, copper, aluminum, fiberglass, and plastics.
These tools are designed to be used with the following
Greenlee tools:
• Standard punches, dies, and drawstuds
• Slug-Buster punches, dies, and drawstuds
®
• Slug-Splitter punches, dies, and drawstuds
®
• SPEED PUNCH Knockout System
®
• Electronic connector panel punches
• Special shape punches, dies, and drawstuds ("D",
Double "D", Key, Square, Rectangular, and Oiltight
with notches)
Standard, Slug-Buster, Electronic Connector Panel
Punches, and special shape punches can punch holes
through mild steel, brass, copper, aluminum, fiberglass,
and plastics, with limited stainless steel capability.
Slug-Splitter punches, dies, and drawstuds are
capable of punching through all of these materials
and are optimized for strainless steel. Refer to the
"Capacity" section in this manual for details information
on maximum driver rating. Do not exceed the rated
capacity of the punch or driver.
Greenlee Tools, Inc.
Hydraulic Knockout Drivers
®
KEEP THIS MANUAL
Quick Draw Hydraulic Knockout Drivers
®

Safety

Safety is essential in the use and maintenance of
Greenlee tools and equipment. This manual and any
markings on tools provide information for avoiding
hazards and unsafe practices related to the use of the
tools. Observe all of the safety information provided

Purpose of this Manual

This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
following Greenlee tools:
Quick Draw Flex™
Quick Draw
Quick Draw 90
Keep this manual available to all personnel.
Replacement manuals are available upon request at
no charge at www.greenlee.com.
Do not discard this product or throw away!
For recycling information, go to www.greenlee.com.
All specifications are nominal and may change as design
improvements occur. Greenlee Tools, Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
Kwik-Stepper, Slug-Buster, Slug-Splitter, and SPEED PUNCH are
registered trademarks and Intell-PUNCH™ is a trademark of
Greenlee Tools, Inc.
2
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
®
®