Installation; Base Station Power Supply; Headphone Power Supply - Philips HD 1500 Instrucciones De Manejo

XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 19

Installation

Base station power supply

1 Make sure the base station's rated voltage corresponds to the mains
socket voltage.
2 Connect the AC power cord to the AC mains socket at the rear of the
base station. Always disconnect the power cord if the base station is not to
be used for a long period of time.
3 In order to disconnect the basestation from the AC mains power, the AC
power cord needs to be unplugged from the AC mains power wall
socket. The AC mains power wall socket should be easily accessible in
normal operating conditions.
IMPORTANT!
• Use only the original rechargeable battery pack (SBC EH2412/00)
• Do not use other NiMH batteries, NiCd batteries or alkaline

Headphone power supply

1 Make sure that the battery pack is positioned correctly in the
headphone's battery compartment
2 Check if the power button of the headphone is in position 'on'.
When the status LED on the headphone starts flashing RED, it indicates
that the batteries are running low.
3 To recharge the headphone's rechargeable battery pack, take them out of
the headphone's battery compartment and put them in the base station's
recharging compartment. The battery pack in the base station's recharging
compartment will be fully charged once the charging indicator LED in the
base station's window is illuminated in green.
Notes:
• Completely flat batteries need approximately 16 hours to
• The charging process is of the so called 'low-rate' class: this will
• The battery pack can not be overcharged: as soon as the batteries
• Always remove the battery pack from the headphone if the
• Batteries contain chemical substances, so they should be disposed
that came with the HD1500 set and which contains 2 pieces of
Philips R06/AA NiMH batteries (1200 mAh).
batteries as these may damage your FM wireless system!
recharge.
result in an increased life span of the batteries.
are fully charged, the charging circuitry switches to 'trickle
charging' in order to keep the batteries in excellent condition.
headphone is not to be used for a long period of time.
properly.
ENGLISH 19