Poulan Pro PP125 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Primer Bulb
Start Lever
Starter
Handle
5. Pull starter rope h andle
sharply
until en-
gine s tarts and runs.
6. Allow u nit torun for 1 0-15 seconds,
then
fully s queeze
the throttle
trigger todisen-
gage the starting
system.
STARTING
A WARM
ENGINE
1.
Move ON/OFF
switch to the ON position.
2.
Squeeze
and
hold the throttle
trigger.
Keep throttle trigger fully squeezed
until
engine runs smoothly.
3.
Pull starter rope sharply while squeezing
throttle
trigger until engine runs.
NOTE:
Normally.
the warm
starting
proce-
dure can be used within
5-10 minutes
after
the unit is turned OFR If the unit sits for more
than 10 minutes without
being ran. it will be
necessary
to start the unit by following
the
steps under STARTING
A COLD
ENGINE or
following
the starting instruction
steps shown
on the unit.
STARTING
A FLOODED
ENGINE
Flooded
engines
can be started
by p_acing
the ON/OFF
switch in the ON position.
Move
the start lever to the RUN position
and fully
squeeze
throttIe trigger.
Pull the starter han-
dle repeatedly
while squeezing
throttle trigger
until engine
starts
and runs. This could
re-
quire pulling the starter
handle many times.
depending
on how badly the unit is flooded.
If
the
unit
still
doesn't
start,
refer
to
TROUBLESHOOTING
TABLE
or
call
1-800-554-6723.
OPERATING
THE
COUPLER
This model is equipped
with a coupter which
enables
optional attachments
to be installed.
The optional attachments
are:
MODEL:
Edger .....................
PPIOOOE
Cultivator
..................
PP2000T
Blower
....................
PP3000B
Brushcutter
................
PP4000C
Pruner
....................
PPS000P
_
WARNING:
Always
stop unit and dis-
connect
spark plug before removing
or instal-
ling attachments.
REMOVING
TRIMMER
ATTACH-
MENT
(OR OTHER
OPTIONAL
ATTACHMENTS)
CAUTION:
When removing
or installing at-
tachments,
place the unit on a flat surface
for
stability.
1.
Loosen
the coupler
by turning
the knob
counterclockwise.
Coupler
Shaft
Lower
\
LOOSEN
Attachment
TIGHTEN
Knob
Press and hold the locking/release
button.
Locking/Release
Button
/ o
oup er _
Upper Shaft
Lower Attachment
3.
While securely
holding
the engine
and
upper shaft, pull the attachment
straight
out of the coupler.
INSTALLING
OPTIONAL
ATTACH-
MENTS
1.
Remove
the shaft cap from the attach-
ment (if present).
2.
Position locking/release
button of attach-
ment into guide recess
of coupler.
3.
Push the attachment
into the coupler until
the locking/release
button snaps into the
primary hole.
4.
Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler
Primary
Hole
' Guide Recess
Locking/
Upper
Release
Attachment
Shaft
Button

Publicidad

Tabla de contenido
loading

Tabla de contenido