Kenmore 66578002700 Manual De Instrucciones página 7

If range h eight adjustment is necessary, use a wrench o r
pliers toloosen t he4leveling l egs.
This may bedone with therange o nitsback orwiththerange
supported on2 legs after t herange h asbeen placed b ack to
astanding p osition.
NOTE: Toplace range b ack upintoa standing position, puta
sheet o fcardboard orhardboard infront o frange. Using 2or
more people, stand range b ack uponto thecardboard or
hardboard.
............ I
, _. _--.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death
or serious burns to children and adults.
2. Adjust the leveling legs to the correct height. Leveling legs
can be loosened to add up to a maximum of 1" (2.5 cm). A
minimum of 3_6" (5.0 mm) is needed to engage the anti-tip
bracket.
NOTE: If height adjustment is made when range is standing,
tilt the range back to adjust the front legs, then tilt forward to
adjust the rear legs.
3. When the range is at the correct height, check that there is
adequate clearance under the range for the anti-tip bracket.
Before sliding range into its final position, check that the anti-
tip bracket will slide under the range and onto the rear
leveling leg prior to anti-tip bracket installation.
f. Remove the anti-tip bracket that is taped inside the upper
oven with the literature package.
2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor you can use the wall
mounting method.
3. Determine and mark edge of range in the cutout space. The
mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout
so that right (or left) edge of the bracket is _%6"(2.4 cm) from
the marked edge of the range, as shown.
A. Anti-tip bracket
B. Mark edge of range
C. 1s/_6" ( 2.4 cm)
4. Drill two %" (3.0 mm) holes that correspond to the bracket
holes of the determined mounting method. See below.
Floor Mounting
A B
Wall Mounting
A. #12x 1%" screws
B. Anti-tip bracket
A
5=
A. #12x 1s/8 ' ' screws
B. Anti-tip bracket
Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1%" screws provided.