Ice Maker Installation; Unpacking - Franklin Chef FIM35 Manual Del Usuario

Ocultar thumbs Ver también para FIM35:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4 Stability supports
(on bottom of unit)
Water supply hose

Unpacking

Use two or more persons to move and install ice maker.
Failure to do so can result in back or other injury.
Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your
ice maker.
Remove tape and glue from your ice maker before using.
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or
glue residue can also be easily removed by rubbing a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can damage the surface of your ice maker.

Ice Maker Installation

Excessive Weight Hazard
7
Control panel
Water inlet
Power cord
Bracket & screws
for stability supports
(4 sets)
Ice scoop

Publicidad

Tabla de contenido
loading

Tabla de contenido