Reverse Osmosis Water Supply; Important - Samsung RF30HB Manual Del Usuario

Removing any residual matter inside the
water supply line after installing the water
fi lter.
1. Turn ON the water supply if you turned it off
when you installed the water fi lter.
2. Run water through the dispenser until the water
runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3. Additional fl ushing may be required in some
households.
4. Open the Refrigerator door and make sure
there are no water leaks coming from the water
fi lter.
Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
DA68-03030A-01.indb 23 DA68-03030A-01.indb 23
All manuals and user guides at all-guides.com

Reverse Osmosis Water Supply

IMPORTANT:

The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi. (241 and 827 kPa)
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi. (276 to 414 kPa)
If the water pressure to the reverse osmosis
system is less than 40 to 60 psi (276 to 414 kPa):
• Check if the sediment fi lter in the reverse
• Allow the storage tank on the reverse osmosis
• If your refrigerator has a water fi lter, it may
If you have questions about your water pressure,
call a licensed, qualifi ed plumber.
English - 23
osmosis system is blocked.
Replace the fi lter if necessary.
system to refi ll after heavy usage.
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water fi lter.
2014. 5. 13. 2014. 5. 13. 2:15 2:15