Cleaning And Maintenance; Technical Specifications - Toolland TM82006 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
6.6
Using the Hammer/Drill Switch
1. Make sure to release the on-off switch and that the drill bit has come to a full stop.
2. Select the desired function. It is recommended to use the hammer drilling function when drilling in
concrete, and the drilling function when drilling in metal or wood. In all cases, do not use the hammer
drilling function when drilling in ceramic tiles or other materials that cannot withstand impact
energy.
3. Press the on-off switch again to use the impact driver.
6.7
Advice on Using the Impact Drill
Always use the auxiliary handle provided with the device. A well-controlled device greatly increases the
working precision.
When drilling ferrous metals:
pre-drill a small hole when a larger hole is required
o
occasionally lubricate the drill bit with oil
o
When drilling at or near the cross cut end or an edge of wood:
pre-drill a small hole in order to avoid cracking of the wood
o
In all cases, do not apply big pressure on the device. The hammer mechanism is activated by applying
a slight pressure on the device when the drill bit is in contact with workpiece.
For the best results, only apply a slight pressure needed to keep the automatic clutch engaged.
7.

Cleaning and Maintenance

Keep the ventilation openings clear, clean and dust-free at all times.
If the device is running erratically or something unusual occurs during use, immediately switch off the
device and unplug from the mains. Inspect the device before using it again. Repair must only be carried out
by a qualified technician.
If the supply cord is damaged, it must be replaced by a qualified technician.
Wipe with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong
detergents.
Clean the device and accessories before storing.
Storing
Store the device, its accessories and this user manual in the original packaging.
Always store in a cool and dry place.
8.

Technical Specifications

power supply ............................................................................................. 230-240 V~, 50 Hz
power consumption ...................................................................................................... 810 W
speed ............................................................................................................... 0-2800 t/min.
cable .............................................................................................................................. 2 m
weight .........................................................................................................................1.7 kg
chuck ......................................................................................................................... 13 mm
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 07/07/2016
TM82006
6
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido