Mode Selection; Wa Ter Tem Per Atu Re - BSVILLAGE EcoPAC 04 Manual De Instrucciones

Start-up and Stand-by

Mode selection

Press MODE to select the unit operation mode
Heating mode

Wa ter Tem per atu re

To set the temperature during working, press ▲ or ▼ to change the setting.
Setting is automatically recorded and display shows working information after few seconds.
To set the temperature during
working, press ▲ or ▼to
show the setting.
Checking of other parameters
When the unit is on standby,
press SET 10 sec to show
parameters.
In stand-by, display will show
ambient temp only.
Press to start the
machine.
Press ▲ or ▼to change the
setting.
Press SET to check the value
of the desired parameter.
In working mode, display will
show water temp (in), ambient
temp (room out) and current
working mode.
Cooling mode
- 23 -
Automatic mode (heating and
cooling)
Setting is automatically
recorded and display shows
working information after few
seconds.
Go out of the setting with ▲
or ▼.