DRAMINSKI ED Serie Instrucciones De Uso página 15

noTe! The depth of probe insertion depends on
the length of the vagina and may vary in different
animals, so you should always follow the principle
of inserting the probe until resistance is felt.
1. Push the power button. Two flashing lines will
be displayed.
--
2. Perform a measurement cycle, remembering
to make 2-3 half turns between each of the
measurements, each time after you push the
power button.
An example of a measurement cycle:
1
14
320
4. Take out the probe from the animal's vagina and
remember or note down the result.
5. Turn off the device by holding the power button
for over 3 seconds or wait until it turns itself off
automatically after 30 seconds
6. Wash and disinfect the device in the manner
shown in the chapter dIsInfectIon
2
3