Sears CRAFTSMAN 247.11683 Serie Manual Del Operador página 9

Recoil Starter Handle
Gas Cap
Control Handle
Chute Assembly
Shave Plate
Auger
Now that you have set up your snow thrower, it's important to become acquainted
with its controls and features. Refer to Figure 1.
NOTE: This Operator's Manual covers several models. Features may vary by model.
Not all features in this manual are applicable to all models and the unit depicted
may differ from yours.
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the
when facing forward in the operation position.
Choke Control
Model: 247.11683*
Model: 247.88780
RUN RUN
CHOKE BELOW
Activating the choke control closes the choke plate on carburetor and aids in starting
engine. The choke lever slides between the RUN and CHOKE positions.
247.11683*
Upper Handle
Auger Control
Primer
Key
Choke Lever
CHOKE CHOKE
OPERATION
Control Handle
Chute Assembly
Shave Plate
Figure 1
Primer
Model: 247.11683*
Pressing the primer, making sure to cover the vent hole when pushing, forces fuel
directly into the engine's carburetor to aid in cold-weather starting.
Recoil Starter Handle
The recoil starter handle is used to start the engine.
Gas Cap
Remove the gas cap to add fuel.
Key
The key is a safety device. It must be fully inserted in order for
the engine to start. Remove the key when the snow thrower is
not in use.
NOTE: Do not turn the key in an attempt to start the engine. Doing so may cause it to break.
9
247.88780*
Auger Control
Recoil Starter Handle
Gas Cap
Auger
Key
Primer
Electric Starter
Button
Electric Starter
Outlet
Choke Lever
Upper Handle
Model: 247.88780*