Velleman DCM268N Manual Del Usuario página 9

• Avoid body contact with ground potential (e.g. metallic terminals, output sockets, lead
clamp...) while measuring. Make sure to be electrically insulated from ground during
measurement.
• Calibration and repair must be performed by a qualified technician. Refer to your local
dealer.
4. Features
• true RMS measurement of AC current and voltage
• large 4000 count LCD display with bar graph
• peak-hold function to record min. and max. readings for current and voltage
• data-hold function
• DCV (0.1mV~ 600V) and ACV (0.1mV~600V) measurements
• ACA and DCA (0.01~1000A) current measurements
• max. Ø for conductor: 30mm
• resistance measurements: 0.1~40Mohm
• frequency measurements: 0.001~4KHz
• capacitance measurement: 0.001nF~40mF
• temperature measurements: -40°C to 1,000°C
• diode test, continuity test and backlight
• K-type thermocouple measuring range: from -20°C to 1000°C
• optional probes (not incl.): SONDE890, SONDE8264
• safety: indoor use only (overvoltage Cat. III 600V)
5. Overview
Refer to the drawings on page 2 of this manual.
1 current clamp
2 clamp trigger
3 rotary function switch
4 data hold button
5 mode select button
6 peak hold button
6. Operation
GENERAL
• When the range of the measured signal is unknown, start measurement in auto-range
mode, and then select range according to indicated value.
• The display shows "OL" when the present range limit is exceeded. Select a higher range
to continue measurement.
• Do not measure voltages > 600 V or current higher than 1000A. Never turn the rotary
function switch [3] during measurement.
• The device will go in sleep mode when no activity is detected for ±20 min.
• For all measurements: pressing the data hold button [4] freezes the currently measured
value until the data hold button [4] is pressed again. The hold-mode is indicated by the
H-symbol in the display.
• To switch on the backlight, press the backlight button [8], to switch it off, press the
backlight button [8] again. The use of backlight will reduce battery life.
• Peak hold function: for AC measurements, pressing the peak hold button [6] once will
show only the maximum measured value on the display [9], indicated with a P
indicator. Pressing the peak hold button [6] again will show only the minimum measured
value on the display [9], indicated with a P
press and hold the peak hold button [6] for ±3 seconds until the P
disappears.
00 (28/11/2008)
DCM268N
7 DCA zero button
8 backlight on/off button
9 LCD display
10 COM jack
11 V·Ω·CAP·TEMP·HZ jack
indicator. To exit the peak hold function,
MIN
4
MAX
or P indicator
MAX MIN
Velleman
®