Packing - INTERSPIRO SPIROSCAPE HP 15 Manual Del Usuario

6

PACKING

Place the cylinder in the bag and firmly tighten the cylinder strap [ref e, figure 5].
1.
Connect the air hose to the regulator and lock it with the pin [ref b, figure 5].
2.
Position the strap with the quick-start ring [ref d, figure 5] outside the bag.
3.
Sparingly apply talcum powder 460 190 130 (or another talcum powder) to the
4.
neck seal.
Pull the zip about one-third closed.
5.
Fold the hood as shown in [figure 6] and place it in the bag; see [figure 5].
6.
NOTE: MAKE SURE THAT THE HOSE IS PLACED ON TOP OF THE CYLINDER AND NOT IS PINCHED BETWEEN THE
CYLINDER AND THE BAG.
Position the strap with the quick-start ring [ref d, figure 5] on top of the hood,
7.
leaving the strap loop outside the bag.
Fit the quick-start ring [ref c, figure 5] to the cylinder valve. Turn the valve knob
8.
anticlockwise to the stop. Make sure that the knob is resting on the quick-start ring.
Close the zip.
9.
NOTE: THE ZIP SLIDER MUST GO ALL THE WAY TO THE END POSITION. THIS IS SO THAT THE ZIP CAN BE
OPENED WITHOUT USING THE SLIDER, BY PULLING THE STRAP LOOP [REF D, FIGURE 5].
Make sure that the pressure gauge can be read through the window on the bag
10.
(the hood should not be visible).
Position the strap loop as shown [ref d, figure 7]. Pull the strap seal [ref a, figure
11.
7] through the small hole in the bag and the small ring [ref f, figure 7]. Secure the
seal as shown in [figure 8].
10