How To Stop Your Pressure Washer - Briggs & Stratton ELITE Serie Manual Del Propietário

HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-743-4115.
To Start Your Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.5 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparing Pressure Washer
for Use" for illustrations.
3. Make sure unit is in level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Squeeze spray gun trigger until steady stream of water
occurs.
6. Place quick connect spray tips in slots on holder
attached to nozzle extension (Figure 9).
Figure 9 — Install Spray Tips in Holder
2800 PSI Pressure Washer
7. Attach nozzle extension to spray gun (Figure 10).
Tighten by hand.
Figure 10 — Connect Nozzle Extension to Spray Gun
8. Choose desired spray tip and insert into nozzle
extension. See "How to Use Spray Tips".
9. Engage safety latch to spray gun trigger (Figure 11).
Figure 11 — Spray Gun with Safety Latch Engaged
10. Start engine according to instructions given in engine
owner's manual. Also see operating instructions tag
located on the pressure washer.
Avoid injury from kickback.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.

How to Stop Your Pressure Washer

1. Let engine idle for two minutes.
2. Turn engine off according to instructions given in
engine owner's manual.
3. Squeeze trigger on spray gun to relieve
pressure in hose.
NOTE: A small amount of water will squirt out when
pressure is released.
9
Safety Latch
CAUTION