How To Stop Your Electric Pressure Washer; How To Use Spray Tips - Briggs & Stratton PW101-2010 Manual Del Operador

How to Stop Your Electric Pressure
Washer
The electric pressure washer motor runs only when the
trigger is engaged. To stop the electric pressure washer
and turn off the motor:
1. Release spray gun trigger.
2. Press the master ON/OFF switch to the OFF (0)
position.
NOTICE Releasing the trigger will shut off the motor but
does not shut off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction, press
trigger lock button and squeeze trigger to relieve built
up pressure in the unit.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when motor
is stopped and water is disconnected, which could result
in serious injury.
• Keep high pressure hose connected to pump and
spray gun while system is pressurized.
• ALWAYS point spray gun in safe direction, squeeze
spray gun trigger to release high pressure, every time
you turn off pressure washer.
5. Disconnect GFCI plug from outlet and coil power cord
on bottom hook of accessory tray.
6. Wrap high pressure hose and store on top hook of
accessory tray.
7. Store spray gun, plastic wand and spray tips on the
accessory tray.

How to Use Spray Tips

There are three spray tips supplied with the pressure
washer. The turbo spray tip whirls a powerful pin-point jet
of water for intense cleaning. The white tipped spray tip is
for general soap applications and the orange tipped spray
tip is for various high pressure applications.
Usage Tips
• For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
• Do Not get closer than 6 inches when cleaning tires.
11