Charging The Battery; Changing The Battery - SOLAC VT8840 Instrucciones De Uso

10. Cord holder
11. Battery access door

CHARGING THE BATTERY

• Charge the appliance before using it for the first time. (Charging is not
necessary if the appliance is used while connected to the mains)
• Recharge the appliance after use and make sure that the 0 position is se-
lected while not in use.
• To charge the battery, connect the appliance to the mains, select the DC
position of the electrical current selector (5) and the 0 position of the speed
selector (6). The charge indicator light comes on confirming that the appli-
ance is charging (Fig. 1).
• Maximum charge is obtained after approximately 20-24 hours of charging.
Once the appliance is charged, it will run for 4 to 5 hours depending on
whether it is used at maximum speed or not.
USER INSTRUCTIONS
• When using the appliance connected to the mains, select the AC option of
the electrical current selector (5) and options 1 or 2 of the speed selector
(6) depending on the air flow preferred.
• When using the appliance not connected to the mains, select the DC option
of the electrical current selector (5) and options 1 or 2 of the speed selector
(6) depending on the air flow preferred.
• To select the swing function, turn the swing selector (9) to the left (Fig. 2).
To stop the swing function, turn the swing selector (9) to the right.

CHANGING THE BATTERY

• Unscrew the 4 screws on the battery access door (11), remove the battery
and replace it with a new 6V4.5AH battery. Screw on the door again to ac-
cess the battery.
Ventilador VT8840 9
9
1/3/07, 16:00:42