Charging The Battery; Changing The Battery; Cleaning And Maintenance - SOLAC VT8860 Instrucciones De Uso

Ventilador
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Libro VT8860.book Page 9 Friday, February 23, 2007 3:19 PM
8. Swing selector
9. Cord holder
10. Battery access door

3 CHARGING THE BATTERY

Charge the appliance before using it for the first time. (Charging is not
necessary if the appliance is used while connected to the mains)
Recharge the appliance after use and make sure that the 0 position is
selected while not in use.
1 To charge the battery, connect the appliance to the mains, select the DC
position on the electrical current selector (4) and the 0 position on the
speed selector (5). The charge indicator light comes on to confirm that
the appliance is charging (Fig. 1).
2 Maximum charge is obtained after approximately 20-24 hours of
charging. Once the appliance is charged, it will run for 3 to 5 hours
depending on whether it is used at maximum speed or not (lower
autonomy at higher speeds). The autonomy may last longer than 6 hours
if you select the slowest speed and the swing function is not used.
4 OPERATION
1 When using the appliance connected to the mains, select the AC option
on the electrical current selector (4) and options 1 or 2 on the speed
selector (5) depending on the air flow preferred.
2 When using the appliance while it is not connected to the mains, select
the DC option on the electrical current selector (4) and options 1 or 2 on
the speed selector (5) depending on the air flow preferred.
3 To select the swing function, push the swing selector (8) to the left (Fig.
2). To stop the swing function, push the swing selector (8) to the right.

5 CHANGING THE BATTERY

• Unscrew the 4 screws on the battery access door (10), remove the
battery and replace it with a new 6V4.5AH battery. Screw on the battery
access door again.

6 CLEANING AND MAINTENANCE

Your appliance must be disconnected from the mains before any
cleaning operation is performed. As well as disconnecting the appliance
from the mains, make sure that the appliance is set at 0.
CHARGING THE BATTERY
en
9

Publicidad

Tabla de contenido
loading

Tabla de contenido