Bematech S-100 Guía De Referencia Rápida página 11

Start of Configuration
RESET
ABORT
SHOW VERSION
USB Interface Cable Notice
Some handheld CCD/Laser scanner contains build-in USB
controller (USB on Board), and this update would only work with
new USB cable (P/N: 171-10U301-200). Please find the "U"
marking on the devices or refer to the latest Buyer's Guide for
more information.
* The default parameter
values are framed.
All program setup must start
with
Configuration" label, and read
the "End of Configuration" label
to save any changes.
Interface Selection
PC/AT
USB
Wand Emulation
reading
The reading
"RESET" label turns all
the parameters back to
default values.
The reading
"ABORT" label discards all
the parameters read prior
to the
configuration".
The reading of the "SHOW
VERSION" label will show
the firmware version.
End of Configuration
the "Start
of
of
"End
10
of
the
the
of