Greencut PRE100 Manual De Instrucciones página 46

46
4. Insert the jack plate hooks (L) through the jack plate, from the jack side, and secure with the wing nuts (M).
Hang the jack plate springs (N) from the eyelets (BB) located on the underside of the top beam of the frame.
5. Place the jack plate assembly inside the frame and hook the jack plate springs to the hooks on he jack plate.
Ensure that the top of the hydraulic jack (CC) sits inside the retainer (DD) located on the underside of the
top beam of the frame. Adjust he wing nuts as required so the jack plate is level and the top of the hydraulic
jack is correctly located when the jack is fully retracted.
6. Insert the press table pins (O) through a hole in the frame legs – one pin per frame leg and in the same hole
so they are level.
J K
L
I
AA
CC
N
H
M
DD
BB