Product Use - Greencut PRE100 Manual De Instrucciones

7. Holding the press table (P) at an angle, place it between the frame legs, then rotate it so it is level and lower
it onto the pins.
8. It s recommended to mount the press to the floor. Ensure
the mounting surface is flat and level, and is capable of
supporting the weight of the equipment and any loads
it generates – preferably concrete. Secure the press using
the holes in the feet and suitable fasteners. Do NOT install
the equipment outdoors or in areas subject to dampness
or high humidity.

PRODUCT USE

1. If necessary, move the press table to the highest possible position that allows the job to be performed. To
move the table, hold i firmly and remove the press table pins. Then, hold the press table in the required
position and insert the press pins in the nearest hole underneath he table. Ensure the pins pass through the
frame fully.
2. Place the work-piece on to the press table. Use the work-piece support plates or suitable objects to properly
support the work- piece, as required.
3. Position the work-piece so that where pressure is required is
directly beneath the pin protruding from under the jack plate.
4. Close the valve on the hydraulic jack by using the slotted end
of the handle to rotate it. Rotate it to the right (clockwise) until
firm
5. Slide the handle into the handle sleeve on the hydraulic jack and
move up and down to "pump" the jack. The jack plate should
move down a little with each pump. When the jack plate makes
contact with the work-piece, pump the jack slowly and apply
only as much pressure as necessary to complete the job. Keep a
close eye on the work-piece when applying pressure.
6. When the job is complete, use the handle o open the valve
(rotate left / anti-clockwise) on the hydraulic jack. Always open
the valve slowly. Allow the jack plate to return to the top-most
position before removing the work-piece from the press table.
O
47
P
EN